Before you start pasting the room with brand new, just brought wallpaper from the store, you need to carefully think. Everyone probably wants the glued wallpapers to serve as long as possible.
Therefore, first it will be necessary to properly prepare the wall for gluing. The following tips will greatly facilitate the preparation for repair.
1) the first step is removal from the wall of old wallpapers. If the wallpaper is also lucky, then it will be easier to remove them. To do this, you just need to pull the end of the panel and it will easily withdraw from the wall.
It’s much more complicated if the old wallpaper is vinyl or paper. In this case, they are hardly removed by shreds from the wall and have to pick up a hard sponge and a hot soap solution.
2) when the wall is cleaned of the old wallpaper and completely dried, the time is time to align the surface. It is necessary to pull out all the unnecessary nails and cloves, the protruding elements cut, remove the sockets and switches.
After that, with the help of a steel spatula and finished plaster with putty, which can also be bought at the building materials store, you need to level the wall. All holes and holes must be filled with plaster, and aligned the “Wanderer”. Then walk on top of the finish putty, giving the wall the same even tone and color.
If you need an office for rent
– Visit BCinform. Only there you will find everything you need to rent offices without overpayments.
If the holes or holes in the wall are quite large, then first you need to fill them with a gypsum mixture, then close the plaster with a layer of plaster and putty.
Sometimes along the entire wall due to an incorrectly erected foundation, you can notice traces of microcrack. To get rid of them, it is necessary to strengthen the wall, and prevent these microcracks do not go further.
A special reinforcing mesh is used to reinforce the surface of the wall. It is sold both with small narrow rolls and a wide canvas. You need to choose the type that is more suitable for your wall.
The reinforcing mesh is attached under the layer of plaster, after which it is additionally fixed with a layer of putty.
3) The next step is to protect the wall from moisture and the influence of the external environment. This is done by applying several layers of protective primer to the wall. Apply it with either a wide flak brush, or a roller. With drying each applied primer layer.
.